China Slewing Ring Bearing suppliers Excavator or Crane Cross Roller Bearing Slewing Bearingnovembre 16, 2021
Slewing Bearing Price – China Manufacturers, Factory, Designnovembre 18, 2021
Internal gear excavator Single Row Cross Roller Support Slewing Ring
Due to the different working conditions of slewing bearings, most of them work under eccentric load. In addition to bearing axial load and radial load, the bearing must also overcome the effect of overturning moment. Therefore, the bearing selection calculation is based on the load-moment diagram. The curve is the method commonly used by major manufacturers at present as the selection method of slewing bearings
According to different structural characteristics, slewing bearings can meet the needs of working hosts under different load conditions. Four-point contact ball slewing bearings have high dynamic load capacity. Crossed cylindrical roller slewing bearings have high static load capacity. Crossed tapered rollers The pre-interference energy of the sub-slewing bearing enables the bearing to have greater support rigidity and higher rotation accuracy. The three-row cylindrical roller combined slewing bearing leads to the improvement of the bearing capacity in the height direction of the bearing. The track and roller set bear, so under the same stress conditions, the diameter of the bearing can be greatly reduced, so it has the characteristics of making the host more compact. It is a high-loading capacity slewing bearing.
After the Fenghe slewing bearing is installed and put into operation, after 100 hours of continuous operation, it should be fully checked whether the pre-tightening torque of the mounting bolt meets the requirements. Repeat the above inspection every 500 hours of continuous operation thereafter.
After the slewing bearing is installed, the appropriate amount of grease should be filled and the slewing bearing should be filled to make the grease evenly distributed. The slewing bearing will inevitably lose part of the grease after working for a period of time. -Lubrication should be added once after 100 hours. For slewing bearings that work in high-temperature environments or dusty conditions, the cycle should be appropriately short. When the machine is shut down for a long time, it must be filled with sufficient grease.